Owner's manual

12. Twist LED & cooling unit into headlamp housing.
13. Plug included wire harness into bottom
of the LED/cooling unit.
14. Plug LED harness into stock 3 prong connector.
15. Replace the headlamp housing into
the headlight bucket.
Note: The 1116-0401 will not work with an internal tri bar lens.
Note: Once the harness is plugged in do not remove.
11. Insert the LED/cooling unit into the headlight housing.
10.Center the L shaped groove on LED/cooling unit
with the two grooves on the protective shield.
1108-0029