Owner`s manual
6 Series OUTPOST
®
Wireless Callbox GateGuard
®
Application
25 Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com
O
PTIONAL
G
ATE
G
UARD
®
S
ETTING
/F
EATURES
(
CONTINUED
)
...............
Send Call Tone............................................... (PC or FP)
The Factory Default setting has the Call Tone feature ON
(refer to “H
OW TO FIELD PROGRAM SINGLE-DIGIT RADIO
FEATURE CODES” on page 14). The callbox can be
programmed to transmit a Call Tone if the Reset Time
has expired and the ON/PTT button is pressed. This will
alert system users that the call is originating from the
callbox.
Ring Tone................................................................. (PC)
This will sound an alert tone on the callbox speaker,
similar to a telephone ring tone, whenever the correct 2-
tone code has been successfully decoded. This feature
is used to alert the Callbox user that the gate is being
opened or closed. Ring Tone is enabled from the
factory.
GateGuard
®
– Toggle ....................................(PC or FP)
Will alternately open and close the Switch Output when it
receives a unique 2-Tone code. After the 2-tone decode
(receive) code is received the callbox will transmit a
single beep if the switch has been opened and a double
beep if the switch has been closed. The switch will open
when the callbox turns off if it is programmed for
Automatic Turn-Off.
GateGuard
®
On Code / Off Code ............................(PC)
This operation allows programming of separate ON and
OFF 2-tone decode (receive) codes. The OUTPOST
®
will CLOSE the Switch Output upon receiving the ON
code, and OPEN the Switch Output upon receiving the
OFF code.
When reading out the radio programming as described in
the “H
OW TO READOUT CURRENT RADIO FREQUENCY & TONE
CODES” section, the ON code will be displayed.
Sensor/Contact Closure Input
The Sensor Input will detect a logic level and transmit an
Alert tone when a change in logic level is detected.
Separate alert tones are used for OPEN (logic level high)
tone and CLOSED (logic level low) tone.
Busy Channel TX Inhibit ...............................(PC or FP)
This will not allow you to transmit when another user is
already transmitting on your radio frequency, even if they
are using a different tone code. The radio will beep a
series of long, low tones (like a busy signal) while the
ON/PTT button is held down.