Owner`s manual

OPERATING THE RADIO
-----------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------------
Ritron RCCR Clean Cab User Manual 3
Ritron, Inc. (800)-USA-1-USA [e-mail]
Channel Zone Set-Up
The RCCR -151 Locomotive Radio can be set-up using the front panel keypad such that any or all of
the available Channel Zones are enabled for normal radio operation. The available zones are:
y Home Channel Zone (1 – 500)
y Wideband Channel Zone (AAR03 – 97)
y Narrowband Channel Zone (AAR005 – 097)
y Narrowband Offset Zone (AAR104 – 197)
y Digital Channel Zone (AAR302 – 488)
IMPORTANT!
DO NOT pause more than 2 seconds between keypad presses prior to the completion of set-up,
otherwise the radio will automatically resume normal operation and the operator must begin at Step 1.
To enable Channel Zones using the front panel keypad:
1. Press CHAN - # - 6 – 2 – 7 – 7 – 6 - 9
2. “CH PLAN” will be displayed on the top row of the LED Display.
3. Referring the table below, press the keypad digits to enable the corresponding channel zone(s)
you wish to enable.
1 – Home Channel Zone (1 – 500)
2 – Wideband Channel Zone (AAR03 – 97)
3 – Narrowband Channel Zone (AAR005 – 097)
4 – Narrowband Offset Zone (AAR104 – 197)
5 – Digital Channel Zone (AAR302 – 488)
4. After last digit is pressed, wait 2 seconds and the radio will automatically resume to normal
operation.
5. If a channel from a list that is not enabled is entered using the front keypad, “INVALID” will be
displayed momentarily (2 sec), and then the last valid channel entered will be displayed.
The following example illustrates a Channel Zone Set-Up to enable only the Narrowband Channel
Zone (3) and Digital Channel Zone (5).
T/D HOME
TX RX
TX RX
# 6 2 7 7 6 9 3 5
CHAN
Press CHAN - # - 6 – 2 – 7 – 7 – 6 – 9 ► CH PLAN is displayed ► Press 3 – 5