Owner`s manual

PROGRAMMING THE RADIO
-----------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------------
Ritron RCCR Clean Cab User Manual 27
Ritron, Inc. (800)-USA-1-USA [e-mail]
Analog Home Channels can be programmed for:
TX and RX Tone
Each Home Channel can be programmed for a unique CTCSS or DCS TX code that will be
continuously sent whenever the transmitter is active, and/or RX code that will quiet the receiver
unless the code is detected. Using the drop-down, scrolling menus you can choose from a list of 51
CTCSS codes, 104 DCS codes, or None.
TX and RX Invert DCS
When checked, it inverts the polarity of the DCS TX and/or RX codes. These selections are only
available if a DCS code is used.
Dispatch Code
Each Home Channel can be programmed with an assigned DTMF or Single-Tone Dispatch Code.
This Dispatch Code will be automatically entered into the radio every time the Home Channel is
selected. DTMF codes can be 1-3 digits while Single-Tone codes can be 1 digit only. For models
that do not allow Dispatch Code programming on a Home Channel this selection will be dimmed and
unavailable.
Digital Home Channels can be programmed for:
TX and RX RAN
The TX and RX RAN (Radio Access
Number) is a unique number used
to help mute unwanted
transmissions on the same RF
frequency. This number can be
between 0 and 63. RAN 0 = no
RAN.
Dest ID
The Destination ID is a unique Unit
or Group ID number that allows the
RCCR to call a specific individual
unit or group depending on the Call
Type selection.
RX Group
RX Group is a unique Group ID
number for the RCCR that specifies a specific group in the NXDN system.
Home Channel Screen with a
Digital Home Channel displayed
Squelch Type
To mute unwanted transmissions, the radio’s squelch mode can be set for RAN, ID, RAN+ID, or Off.
RAN
To unmute the radio, the transmitted TX RAN must match the receiving radio’s RX RAN.
ID To unmute the radio, the transmitted Destination ID must match the receiving radio’s
Unit ID or Group ID number depending on the Call Type.
RAN+ID
To unmute the radio, both the TX and RX RAN’s and the Destination and RX Group ID’s
must match.
Off
The radio will unmute with any transmission on the channel.
Call Type
The Home Channel can be programmed to transmit either an Individual or Group Call.