Owner`s manual

PROGRAMMING THE RADIO
-----------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------------
Ritron RCCR Clean Cab User Manual 23
Ritron, Inc. (800)-USA-1-USA [e-mail]
Options
Frequencies
Four checkboxes are used to
enable the AAR channels available
for selection with the front-panel
CHAN button. If not checked, the
channels cannot be selected with
the CHAN button, but are still
available for programming to a
Home Channel.
Wide Band Enable (03-97)
When checked AAR channels 05-
97 will be available for selection
with the CHAN button.
Option Settings Screen
Narrow Band Enable (005-097)
When checked AAR channels 005-097 will be available for selection with the CHAN button.
Narrow Band w/Offset Enable (104-197)
When checked AAR channels 104-197 will be available for selection with the CHAN button. This
option is only available if Narrow Band Enable has been checked.
Digital Enable (302-488)
When checked AAR channels 302-488 will be available for selection with the CHAN button. For
radio models without Digital Channel capability this selection will be dimmed and unavailable.
Advanced Options
Fixed Home Mode Dispatch Tones
When checked this will affect how Home channels are displayed when using DTMF or Single-Tone
dispatch tones. When on a Home Channel the display normally shows either the Home Channel
number or an alphanumeric description. When Fixed Home Mode Dispatch Tones is checked the
radio will not display the Home number or alpha description if a dispatch code is changed via the
numeric keypad. The radio will still operate on the Home channel frequencies, but the display will
only show the RX and TX channels and the entered dispatch code. If the Home Channel is re-
selected via the HOME button it will revert back to the normal display. For some models this
selection will be dimmed and unavailable.
Dispatch Sequences
If checked the radio will allow DTMF dispatch codes of 1-3 digits, otherwise it will only allow single-
digit entries. For some models this selection will be dimmed and unavailable.
Antenna Fault Detector Enable
When checked a message will appear on the display whenever there is an antenna fault condition.