Owner`s manual

________________________________________________________________________________________________

For assistance, call RITRON at 800-872-1872, or go to www.ritron.com

DENTIFICATION OF QUICK ASSIST

CONTROLS AND CONNECTIONS ..............................................................................................

1 Battery Holder

The battery holder accommodates the six (6) standard AA

alkaline cells required to power the Quick Assist

NOTE:

Always install a fresh set of alkaline batteries

before programming the unit.

2 Front Panel LED

The red front panel LED is lit whenever the Quick Assist

is transmitting a message.

3 SMB Antenna Connector

This connects the internal antenna to the radio printed

circuit board.

4 External Audio Input

Allows input to the Quick Assist

voice recorder from an

external audio source, such as the Line Out audio from

your computer.

5 Microphone

Microphone for recording voice messages.

6 USB Programming Connector

Connects the Quick Assist

to the USB port on your

computer for programming.

7 Record Button

Press this button to initiate voice recording.

8 Internal Antenna

The internal antenna radiates radio signals.

9 Front Panel Push Button

When the front panel push button is pressed the Quick

Assist

transmits your pre-recorded voice message. This

sealed push button provides a water-resistant enclosure.

10 Battery Connector

In-line connector between the printed circuit board and the

battery holder.

IMPORTANT

: Do not remove any other fasteners or

further disassemble the Quick Assist

unit; doing so risks

damage to the unit and voiding the manufacturer’s

warranty.

FIG-1: CONTROLS & CONNECTIONS

9 10