Owner`s manual

For assistance, call RITRON at 800-USA-1-USA (800-872-1872) or visit us at www.ritron.com
qtm9322b.pm5
ABOUT THE QUICK ASSIST
®
II WIRELESS CALLBOX TRANSMITTER
GENERAL INFORMATION
The Quick Assist II is a RITRON Wireless Callbox
Transmitter, specialized for indoor retail or commercial use,
and pre-programmed to transmit a custom-recorded
"assistance needed" message when the Message
push-button is pressed for customer assistance. Personnel
know from these message transmissions in which specific
areas a customer needs assistance.
The Quick Assist II is easily programmed to transmit on
either an existing or a new radio frequency, with the most
popular sub-audible coded squelch formats, such as
Quiet Call
®
or Digital Quiet Call
TM
. This enables all your
personnel with JOBCOM
®
, PATRIOT
®
or equivalent two-
way radios to hear the voice messages instantly.
The Quick Assist II can be installed in a wide variety of
indoor locations. Because its six internal AA Alkaline
batteries will power the unit for about a year, the Quick
Asssist II does not require AC line power.
QUICK ASSIST II MODELS AND FREQUENCIES
There are two Quick Assist II models, one for each of the
most popular professional radio communications bands.
The model number appears on a label on the bottom of
the case.
MODEL BAND FREQUENCY RANGE
RQA-150 VHF-FM 150 to 165 MHz
RQA-450 UHF-FM 450 to 470 MHz
Ritron manufactures mobile, portable and base station
two-way radios and repeaters for use with the Quick
Assist II. Ritron pioneered the use of Color Dots on radios
to identify frequencies.
 1 
Default RQA-150 RQA-450
Transmit Frequency 154.570 MHz 467.850 MHz
Coded Squelch none none
Assistance Needed Message Switch 1 Closed Switch 1 Closed
Time Between Messages 30 sec 30 sec
Low Battery Message Low Battery Low Battery
Message Repeat Limit 2 times 2 times
Default RQA-150 RQA-450
Transmit Frequency 154.570 MHz 467.925 MHz
Coded Squelch none none
Assistance Needed Message last message programmed
Time Between Messages on changes only - message
will be transmitted anytime
the button is pressed
Low Battery Message last message programmed
Message Repeat Limit forever forever
QUICK ASSIST II FACTORY PROGRAMMED DEFAULTS:
Since the radio board assembly in the Quick Assist II can be programmed to meet a
wide variety of uses, programming options may be different for each use. For Models
RQA-150 and RQA-450, the programmed Factory Defaults are as follows;
QUICK ASSIST II RESET DEFAULTS:
If for some reason a reset is performed on the Quick Assist II(refer to page 4),
the reset defaults may be different from the Factory Programmed Defaults.
They are as follows;
Note: Even though the messages do not change, it is recommended that they be
re-recorded after a reset has been performed. Even if your message is shorter
than the allotted message time, the transmitter will be on for the full amount of
allotted message time.
Model
Model Model
Model