User's Guide

3.
Display Icons
Removing the Battery
1. Turn off the radio.
2. Slide the latches located on both sides of
the battery downwards at the same time.
3. Pull the top part of the battery away from
the radio’s body, and remove the battery.
Attaching the Battery
1. Fit the tabs at the bottom of the battery into
the slots at the bottom of the radio’s body.
2. Press the top part of the battery towards
the radio until both latches rmly attach
to the radio.
7. Up/Down
Scroll Buttons
3. LCD Display
6. Menu
5. Microphone
2. Speaker
10. Accessory
Connector
12. Spring Action
Belt Clip
11. Battery
Release
Latches
**16.
**17.
**18.
Scramble Indicator—Appears when
Voice Scrambler is ON.
CTCSS or DCS Tone Programmed.
Scan Indicator—Appears when
Channel Scan is ON.
“Hands-Free” VOX Indicator —Appears
when Hands-Free feature is ON.
Signal Strength Indicator—shows received
signal strength of an incoming transmission.
4 Bar = Strong Signal
3 Bar = Moderate Signal
2 Bar = Acceptable Signal
1 Bar = Very Weak Signal
Battery Level Indicator
3 Bars = Full Charge
2 Bars = 66%
1 Bar = 33%
H/L—Indicates Power (high or low) setting
of individual channel.
Keypad Lock—Appears when keypad
tones lock is ON.
Bell—Appears when keypad tones are ON.
Icons / Function
To provide additional feed-
back to the radio user, the
LED display has several
status icons. Some status
icons are “radio wide”.
Other icons appear only IF
the feature is set to ON for
the current operating channel.
4.
1. Antenna
2. Speaker
3. LCD Display
4. On-Off / Volume Knob
5. Microphone
6. Menu Serves as Menu Button in
Field Programming Mode.
7. Up/ Down Scroll Buttons
8. LED Indicator —Lights RED while
transmitting. Lights Green while
receiving a call.
9. Push to Talk Button (PTT) —Push and
hold to transmit; release to listen.
10. Accessory Connector —Connects head
sets, remote speaker/microphones and
other accessories. Replace attached
dust cap when not in use.
11. Battery Release Latches
(right and left sides)
12. Spring Action Belt Clip
1. Antenna
9. PTT Button
8. LED Indicator
4. Volume Knob
*13. Orange Button
*14. 2 Dimples
*15. 1 Dimple
Programmable Function Buttons (PFB)
* These buttons can be re-programmed
for one of several functions using only the
optional PC Programming Software.
**These buttons can be re-programmed for
one of several functions using
Field Programming. (refer to page 12 & 13)
Button Default Feature Setting
13. *Orange Emergency Call
14. *2 Dimples Monitor (press momentary)
15. *1 Dimple Backlight
16. **F1 Low TX Power
17. **F2 2 Tone Send
18. **F3 Scan
Radio Buttons & Controls