User's Manual

particular model use. In addition, there are five other tabs and five buttons that can be selected. These are
summarized below:
5.2 PAGE TABS
The page tabs show up on all of the pages. Clicking on a tab moves one to that page.
Frequency-as explained above, this page allows the observing and entering of operating frequencies.
The other tabs are shown below and their contents will be detailed in later sections.
General-shows the general operating parameters of the modem.
Modem-shows the modem parameters such as protocol, etc.
Analog-shows the parameters of the analog/voice path.
Summary-shows all of the parameters of the modem on one page.
Restore EE-allows the configuration of the programmed radio modem to be saved.
5.3 BUTTONS
There are five buttons which show up on all of the pages. These are:
Receiving-This is a software (programmer) PTT selection. Selecting this button will put the radio modem
in transmit mode, regardless of the state of the PTT pin. Selecting this button again will return the radio
back to receive.
Monitor- This is a software (programmer) Monitor selection. Selecting this button will unmute
theanalog/voice receiving path of the radio modem. Selecting this button again will return the radio back to
normal squelched operation. Note that if unsquelched operation is selected on the Analog page, this button
will have no effect.
Clone Radio-This allows the radio parameters to be copied into another radio.
Update Radio-Loads the programmer’s parameters into the radio. Note that changes made via the
programmer are NOT permanently saved into the radio until this button is selected. The radio’s behavior
will change as changes are made via the programmer, but will be lost on power-down unless, and
until, this selection is made.
Read Radio- Reads the radio modem’s parameters into the programmer for observation and editing.