User's Manual

________________________________________________________________________________________________________________________________
For assistance, call RITRON at 800-872-1872, or go to www.ritron.com
7
Setting the LOCATION switches for Standard Operation Only
When set for Standard Operation with the RQT-xxx-PS model Quick Talk™,
the RQA-1B/4B can also be set to send 1 of 15 different “Location” codes to
further identify the unit. Location messages are recorded into the Quick
Talk™ the same as voice messages.
Set the LOCATION switch code for the RQA-1B/4B per the following chart:
SW1
SW2 SW3 SW4
No Location OFF OFF OFF OFF
Location 1 ON OFF OFF OFF
Location 2 OFF ON OFF OFF
Location 3 ON ON OFF OFF
Location 4 OFF OFF ON OFF
Location 5 ON OFF ON OFF
Location 6 OFF ON ON OFF
Location 7 ON ON ON OFF
Location 8 OFF OFF OFF ON
Location 9 ON OFF OFF ON
Location 10 OFF ON OFF ON
Location 11 ON ON OFF ON
Location 12 OFF OFF ON ON
Location 13 ON OFF ON ON
Location 14 OFF ON ON ON
Location 15 ON ON ON ON
Setting the ADDRESS
For convenience, the RQT-433-RCVR receiver installed in the Quick Talk™
and all RQA-1B/4B Wireless Call Buttons come from the factory set to the
same address. This establishes a relationship between a single RQT-433-
RCVR receiver and multiple RQA-1B/4B with different codes. For the vast
majority of users the address does not need to be changed. Occasionally
the user may want to change the address to:
• Install two or more RQT Quick Talk™ with RQT-433-RCVR receivers in
the same location.
• Avoid interference with another transmitter using the same address.
• Create a more secure “non-standard” address.
The RQT-433-RCVR receiver and RQA-1B/4B transmitters allow the
selection of one of 1,024 unique addresses. To avoid contention with other
units or to create unique relationships, the address can be changed. This is
accomplished by cutting PCB traces with a sharp object, such as an X-Acto
knife.
On the RQA-1B/4B Wireless Call Button the traces are accessed by
removing the front cover. If the trace is intact, the address line is connected
to ground, otherwise it is floating. The RQT-433-RCVR receiver address
must match exactly in order for the units to communicate.
IMPORTANT!
The RQA-1B/4B and the RQT-433-RCVR receiver installed in the RQT Quick
Talk™ housing must be set to the same address.
RQA-1B/4B Address Programming
RQT-433-RCVR Address Programming
RQT-433-RCVR
A
ddress traces
RQ
A
-1B/4B
Address traces