User's Manual

2) Board Separation
Remove the two screws that secure the control/loader board to the rear bracket. The rear bracket stays
connected to the RF board. Remove the two screws that secure the RF board to the front bracket. The
front bracket stays connected to the control/loader board. These four screws are removed with a
TORX T-9 driver. The two boards are held together by their interconnecting header/socket. Gently
pry the two boards apart at the header/socket. The RF board is then rotated and tilted so to allow the
right angle BNC connector to pass through the hole in the front bracket.
3) Re-assembly is the reverse of assembly with the rear screws installed before the side screws.