User's Manual

2) Board Separation
Remove the two screws that secure the control/loader board to the rear bracket. The rear
bracket stays connected to the RF board. Remove the two screws that secure the RF board
to the front bracket. The front bracket stays connected to the control/loader board. These
four screws are removed with a TORX T-9 driver. The two boards are held together by their
interconnecting header/socket. Gently pry the two boards apart at the header/socket. The
RF board is then rotated and tilted so to allow the right angle BNC connector to pass through
the hole in the front bracket.
3) Re-assembly is the reverse of assembly with the rear screws installed before the side
screws.