Owner`s manual

Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com
CONTROL & OPERATION
IMPORTANT: CHARGE THE BATTERY PACK before using the radio for the first time. Refer to Batteries, pages 11 and 12.
page 2
1 ANTENNA
The flexible antenna radiates and receives radio signals.
Screw the antenna base all the way into the threaded
bushing on top of the radio.
NOTE: Use only the type of antenna furnished with the
radio. VHF and UHF antennas are not
interchangeable.
2 ON/ VOLUME UP
To switch the unit On, press the On/ Volume Up button; the
speaker will emit a turn on beep. If the radio turns on to the
Scan Channel it will emit the Scan Beep. Once the radio is
On, press this button to increase volume.
3 VOLUME DOWN/ OFF
Press the Volume Down/ Off button to decrease volume.
To switch Off the unit, press and hold this button until the
speaker emits a double beep.
4 PUSH-TO-TALK SWITCH (PTT)
Press and hold the PTT when transmitting; release it to
receive.
5 CHANNEL SELECTOR
Press the button and the radio will emit the channel beep,
advance the channel, and the channel display will show
the new operating channel. When the Scan Channel is
selected the radio will emit the Scan Beep and the radio will
begin scanning.
6 BATTERY ACCESS DOOR
(CASE BOTTOM)
The battery access door may be removed to access the
battery pack. Refer to "FIG-7: Battery Access & Installation"
on page 11.
7 JACK COVER
This rubber cover seals out dust and moisture, etc. Snap
the cover into the audio accessory jack and charge jack
openings when the jacks are not in use.
8 AUDIO ACCESSORY JACK
The audio accessory jack is used to plug in earphone
options, and, in conjunction with the charge jack, to connect
an optional remote speaker/ microphone or a single-or dual-
ear headset. This jack is also used for PC programming.
9 CHARGE JACK
The battery pack may be charged through this jack using
the RITRON charger cube. Refer to Accessories, page ii,
for additional charging options.
10 CHANNEL DISPLAY
The channel display will indicate the current operating
channel. When the Scan Channel is selected the display
will rapidly flash the channels being scanned, and will stop
when a channel is received.
11 SPEAKER
The speaker, located behind the front grille, allows you to
hear calls on your channel.
12 MICROPHONE
The microphone allows your voice to be heard in
transmissions to other radios. Speak in a normal tone;
shouting does not improve your listener's reception.
13 DROP-IN CHARGING CAPABILITY
Two contacts, in the bottom of the radio, permit charging
the battery pack with an optional drop-in charger. Refer to
"Optional Charging Accessories" on page 11.
CH
ON
OFF/HOLD
VOLUME
FIG-1: RADIO CONTROLS & CONNECTORS
1
3
4
5
6
7
8
9
11
12
13
10
2