Owner`s manual
page 3 RITRON, INC. 1-800-USA-1-USA
(1-800-872-1872)
For assistance, call
800-USA-1-USA800-USA-1-USA
800-USA-1-USA800-USA-1-USA
800-USA-1-USA
(800-872-1872)
HOW TO PROGRAM YOUR JMX/ SST
To match other radios, the owner can select FREQUENCY and QUIET CALL TONE CODES from tables factory-programmed
into the radio. See Tables 1 and 2, page 5.
1. Choose your frequency codes (Table 1), and QC codes, if desired (Table 2). Programming channel 2 is optional. Note that
each code consists of two digits. Write down the digits of the codes you are going to program in the space provided below.
2. Follow the instructions in FIG-4, page 4, to place the radio in the Program/ Readout Mode.
3. Enter codes in the sequence shown in Step 1 by clicking the PTT the number of times equal to each digit of the code.
EXAMPLE: Two-digit code "04" — click the PTT ten times to program "0", and pause. The radio emits a low tone.
Then click the PTT four times to program "4", and pause. The radio emits a low tone.
4.
When all the digits are programmed, press and release On/ Volume Up to save your programming; the radio emits a triple beep.
NOTE: An error tone will sound if you attempt to save an incorrect digit. Turn the radio off, check the digits you are attempting
to enter, then start over at Step 2.
5. Turn the radio off and then on again — the radio is now ready to use
NOTES: 1. Ten (10) PTT clicks = 0 (zero).
2. Program "44" to enter "No Code" for Quiet Call. You must enter "44" to match radios not having tone codes.
3. IF YOU MAKE A PTT CLICK ERROR, turn the radio off then on, and start over.
4. If the radio does not emit a confirming triple tone when you attempt to enter Program/ Readout Mode, the radio was
factory or dealer customized to disable programming. Consult the radio owner or your dealer.
5. Refer to Frequency and Tone Code (Quiet Call®) tables on page 5.
*
The radio pauses to emit a low tone at the end of each beep series.
CHANNEL 1:
Frequency Code
1st
digit
2nd
digit
ANNEL 1:
Tone Code
3rd
digit
4th
digit
# of PTT # of PTT # of PTT # of PTT
clicks clicks clicks clicks
Pause;
radio emits
a low tone.
Pause;
radio emits
a low tone.
Pause;
radio emits
a low tone.
CHANNEL 2:
Frequency Code
5th
digit
6th
digit
ANNEL 1:
Tone Code
7th
digit
8th
digit
# of PTT # of PTT # of PTT # of PTT
clicks clicks clicks clicks
Pause;
radio emits
a low tone.
Pause;
radio emits
a low tone.
Pause;
radio emits
a low tone.
Pause;
radio emits
a low tone.
****
page 6
FF
FF
F
Continue the programming
sequence if you are entering
digits for Channel 2.
Pause;
radio emits
a low tone.
****