Instructions

Check for proper alignment.
8. Using 3M storage tape hinge the top of the elevon placing 2/3 of the
storage tape on to the wing and 1/3 on to the Balsa control surface.
9. Once both sides of the top have been finished flip the wing over. Flip the
elevons on top of the wing exposing the root of the elevon. Use 3M
storage tape to place 50% of the storage tape on to the bottom of the
wing and 50% on to the elevon. This will create a strong and true hinge.
See video online for this process.
L. Mounting Winglets
L. Mounting WingletsL. Mounting Winglets
L. Mounting Winglets
1. Winglets should be mounted symmetrically with an even amount above
the wing and an even amount below the wing.
2. The end of the wing should be capped and laminated.
3. Apply a thin bead of hot glue on the wing end and press winglet into
place.
4. After the hot glue has cooled use Goop to run a small bead around the
perimeter where the winglet meets the wing. The hot glue is used to hold
the winglet in place until the Goop has dried. The Goop is the main
strength of attachment. Do not apply Goop directly to bare foam.
M. Attaching control rods
M. Attaching control rodsM. Attaching control rods
M. Attaching control rods
1. Center servos.
2. Attach control rods and mount control horns to elevons.
ZII Specs
ZII SpecsZII Specs
ZII Specs
1. Wing Area= 770 square inches of wing area
2. CG is located on the bottom 9 3/8‘’ to 9 1/2’’ from the nose back.