Instructions

F.F.

Install gear

Install gearInstall gear

Install gear

1. The ZII was designed to accommodate multiple types of set-ups,

including FPV, UAV, AP sport flying, and night flying.

2. Setting up gear is up to the user.

3. The main battery bay was designed to accommodate up to (2) 4S

3300 mhr lipos. 4S 4000's by selected manufacturers will also fit.

4. The main battery bay can be modified and utilized for FPV and UAV

electronics.

5. The ZII servo slots are designed for standard size servos.

Manufacturer recommends servos with 70 inch ounce of minimum

torque.

6. Prior to installing servos, you will need to clear the area of the foam

where the wire will exit the servo. This should be done with a small

Xacto knife.

7. After clearing the foam make a slit with a razor from the servo to the

electronics area.

8. Servos may be installed with thick CA or low temperature hot glue

applied to the servo, allowing glue to cool so that it does not melt the

foam. Drop servos in place.

9. Clear small slot or hole on divider between the electronics bay and the

battery bay to clear channel for ESC wires to penetrate the battery

bay area.

G.G.

Placing battery bay lid and electronics bay lid

Placing battery bay lid and electronics bay lid Placing battery bay lid and electronics bay lid

Placing battery bay lid and electronics bay lid

1. Lay the lid on the battery bay area, mark ending point, and trim to

length with scissors. Do the same for the electronics area.

2. Carefully flip lid over and slice the flute at 50% of the length of the lid,

making the top side act as a hinge. This will allow for access to the

battery bay to slide in battery and close lid.

3. Repeat the process on the electronics bay and size for proper opening