Instructions

4. Let tack for 3-4 minutes, place on flat surface, and take caution to
align the roots true.
5. Babysit this joint to ensure a solid bond.
6. Use large snap razor (with new blade) to slice off the raised filler
buttons produced during manufacturing. Use multiple passes in same
direction, following the contour of air foil.
7. Use sanding block with 200 to 250 grit to smooth out surface where
filler buttons were trimmed.
8. Place airplane on surface face up.
9. Pre-fit motor mount and check for proper alignment. Make any
adjustments necessary at this time.
10.Mix approximately ½ ounce of 5 Minute Epoxy. Using a Popsicle stick
or like object, massage epoxy into motor mount slit. Slide in motor
mount plate and align. Gorilla mixed with a small amount of water can
be used as an alternative to appoxy.
11.Using small pieces of tape around the perimeter of motor mount slip,
use tape to pull motor mount slit closed. This applies pressure to
ensure proper bond.
C.
C.C.
C. Install main,
Install main, Install main,
Install main, dark
darkdark
dark-
--
-colored fiber glass tube spars
colored fiber glass tube sparscolored fiber glass tube spars
colored fiber glass tube spars
1. Place wing facing bottom up.
2. Using dark gorilla glue with no water, place one large bead in the
bottom of spar slot.
3. Drop in main spar using blunt tool.
4. Run a bead of thick CA glue on top of the first spar then activate so
spar will not float.
5. Put a bead of dark gorilla on top of the first spar and sprits with a
little water and use a stick to run back and forth to mix the water ,
Now drop in the second spar.
6. Put a few large drops of CA on top of second spar, and lock down with
CA activator (kicker) this will keep from floating when the gorilla is