Instructions
Any flat color will work well, and all paints should be applied in multiple, light
coats. Manufacturer suggests using extreme caution when using dark colors,
as it can melt, attack, and/or destroy the foam. When flat colors are
laminated, they will become glossy.
Approved Filler:
Approved Filler:Approved Filler:
Approved Filler:
Patch and Paint Lightweight Spackling
**Caution needs to be used when using solvent-based paints. EPOR is not as
forgiving as EPP. If you are using spray adhesives and/or paints, very light coats
should be used so solvents are not in concentrated amounts. It is suggested
by manufacturer to stay away from covering large areas with dark, solvent-
based paints. Dark colors should be used sparingly. Manufacturer also
suggests that Goop is used only on installing winglets, if the area to be mated
with winglet has a layer of laminate between the foam and the winglet. Regular
CA, Foam Safe CA, or low temperature hot glue are all good options for gluing
down the corroplast lid edges. Use caution when using hot glue and be sure it
low temperature so it does not melt the foam. Thick versions of each of these
glues are recommended. Take caution when curing large pools of CA with
activator, as this creates a large amount of heat and may melt foam in these
areas.
Build Instructions:
Build Instructions: Build Instructions:
Build Instructions:
A.
A.A.
A.
Prepare work area
Prepare work areaPrepare work area
Prepare work area
1. Area should be large and flat.
B.
B.B.
B.
Join wing halves
Join wing halvesJoin wing halves
Join wing halves
1. Follow flat plane and measure down 3/8 inch from top of motor plate
shelf. Draw a line and follow the same plane. This will allow you to set
the motor plate approximately 1/8 inch above the spar.
2. Pre-fit motor mount plate using a balsa saw or hack saw blade to fit
into desired position. Flush with the trailing edge of motor cut out.
3. Lightly spray root with multiple light coats of 3M 90. *Take extreme
caution to not allow the adhesive to pool, as it may damage the foam.