Quick Start Manual

PG 8
PG 7
5 Install Batteries cont
• Replace front of control unit on the
wall unit
6 Check Unit
8045 Features
Follow these procedures to verify
you have correctly installed the
unit.
• To check HEAT mode:
• Set the mode switch to HEAT. 
• Turn TEMP DIAL counter clockwise to its stop.
This is the warmest setting. Allow the system 5
min to respond. Verify that heat is coming from
the system.
• Return dial to comfortable setting.
The 8045 can be used with
most 110/220 volt electric
heating devices. It provides
Line voltage control for
radiant cable, electric
baseboard, and resistive-
rated fan forced heaters
within the ratings listed. 

Electrical Rating - 
120/208/240 Vac; 
16A resistive load