Instructions / Assembly

www.RiteScreen.com | 1-800-949-4174 | [e-mail]
3. Beginning at the left-most lower corner of the long side of the frame, place the end of the spline down onto
the mesh and using the roller tool provided, start to roll the spline so that both the mesh and spline go down
into the frame groove. Do not overstretch the spline as you insert it. (Note that the roller tool has slightly
different rollers on each endyou may nd that one end is easier to work with than the other). Mesh
should be held/pulled reasonably taut while you continuously insert the mesh and spline down into the frame
groove by rolling the tool as you proceed to the right end of the frame.
4. Once you get to the right most edge of the frame groove, push the spline and mesh down into the very corner
of the frame.
5. Then proceed to install the mesh into the rst SHORT side of the frame, similarly to how you installed it into
the rst LONG side. Remember to always pull the mesh taut while installing spline, for all (4) sides of the
frame.
6. When you get to the SHORT side corner of the frame, again, tuck the spline and mesh down into the frame
corner as you did previously.
7. Continue inserting the spline and mesh into the other LONG side and tuck both in at the corner, as before.
8. Finally, insert spline and mesh into the remaining SHORT side of the frame, as before.
9. Using a utility knife (not provided), cut the spline and push the end of it down into the nal frame corner.
10. You should now have mesh protruding above all four sides of the frame.
11. Using a utility knife, cut all the mesh that protrudes above and beyond the frame.
STEP 4………..Install tension spring, expander, adjustment screws into top/bottom rails.
1. Install the tension spring as shown into the top/bottom rail (FIG. 6).
2. Then, place expander with rollers over the tension spring and into the top/bottom rail (FIG. 7). Make sure that the (2)
round “dimple” marks near the bottom of the expander align with the (2) long slots in top/bottom rail.
Figure 6
Dimple
Install Tension Spring
Install expander w/
rollers so that dimples
in expander align with
slots in top/bottom rails.
Make sure expander is
fully collapsed and then
install truss head screws
through bottom of slots
and into dimples of
expander.
Figure 7