Instructions / Assembly

ManualsBrandsRITESCREEN ManualsDoors & WindowsKnock Down 30 in. x 80 in. White Aluminum Sliding Patio Screen Door with PetMesh

www.RiteScreen.com | 1-800-949-4174 | InsideSales@RiteScreen.com

Description QTY Appearance

Frame with Handle

Frame without Handle

Top/Bottom

Rails & Expanders

48” x 84” Roll of Screen

Mesh

Strike and Screw Set

Roll of Spline

Bugstrip

Spline Roller

Tension Springs

CONTENTS INCLUDED:

TOOLS REQUIRED/RECOMMENDED:

Phillips Screwdriver

or Drill

Safety GlassesPliers Utility Knife

Ultimate Knock-Down Door Kit

Assembly Instructions

Summary of content (5 pages)

PAGE 1
Ultimate Knock-Down Door Kit Assembly Instructions CONTENTS INCLUDED: Description QTY Frame with Handle 1 Frame without Handle 1 Top/Bottom Rails & Expanders 2 48” x 84” Roll of Screen Mesh 1 Strike and Screw Set 1 Roll of Spline 1 Bugstrip 1 Spline Roller 1 Tension Springs 2 Appearance TOOLS REQUIRED/RECOMMENDED: Pliers Utility Knife Safety Glasses www.RiteScreen.com | 1-800-949-4174 | InsideSales@RiteScreen.
PAGE 2
SCAN THE QR CODE FOR EASY TO FOLLOW VIDEO ASSEMBLY INSTRUCTIONS FOR ASSEMBLY OF YOUR PATIO SCREEN (Tools required: Philips head screwdriver/drill, Utility knife, safety glasses/goggles, pliers, roller tool (supplied)) USE SAFETY GLASSES/GOGGLES FOR EYE PROTECTION DURING SCREEN ASSEMBL STEP 1……..Remove the outside handle from the long side piece by removing the 3 screws and set screws aside to be reinstalled later (FIG. 2). (NOTE: Inside handle will now be loose).
PAGE 3
1. Remove tape to separate the expanders from both the top and bottom rail pieces (note that the top and bottom rail pieces containing the expanders are identical to one another, and either can be used at the top or the bottom). 2. Place the top/bottom rail against the long side piece which contains the corners in both ends (FIG. 4). Make sure to orient both pieces as shown, aligning the screw holes in the top/bottom piece with the “dimples” in the corner. Using a Power Drill with a 2.
PAGE 4
3. Beginning at the left-most lower corner of the long side of the frame, place the end of the spline down onto the mesh and using the roller tool provided, start to roll the spline so that both the mesh and spline go down into the frame groove. Do not overstretch the spline as you insert it. (Note that the roller tool has slightly different rollers on each end----you may find that one end is easier to work with than the other).
PAGE 5
3. Compress the expander to collapse it as far down into the top/bottom rail as possible. With expander in this fully collapsed position, install the two No. 8 x 3/8” long TRUSS head screws thru the bottom of the slots and into the dimples of the expander-----DO NOT COMPLETELY TIGHTEN SCREW SO THAT EXPANDER CAN MOVE FREELY. 4. Repeat steps 1-3 for the other expander. STEP 5………Re-install outside handle that was removed in STEP 2 (FIG. 8). Reinstall Handle Figure 8 1.