User guide
SUPPORTS
AIR LINE INSTALLATION
FIGURE “D”
PLEASE TAKE ALL NECESSARY
SAFETY PRECAUTIONS WHEN
INSTALLING YOUR COIL-RITE KIT.
NYLON TIES
AIR LINE
FIGURE "E"
FIGURE “C”
STEP 5 — ROUTE THE AIR LINE
Cut the remaining air line tubing into two equal lengths
(cut the tubing as squarely as possible). Select a loca-
tion for the ination valves in a protected area, such as
the bumper or trunk oor (Note: The ination valve will
be installed in Step 6).
Insert the air line tubing into the push-to-connect t-
ting on the air spring as far as possible. Route the tubing
from the air spring to the ination valve, making sure
to avoid direct heat from the engine, exhaust pipe and
away from sharp edges. Secure with nylon ties provided
in your Coil-Rite kit.
STEP 6 — INSTALL THE AIR LINE AND
INFLATION VALVE
Select a location on the vehicle for the air ination valves.
The location can be located on the bumper or the body
of the vehicle, as long as it is in a protected location so
the valve will not be damaged, but maintain accessibility
for the air chuck see Figure “D”. Drill a 5/16" hole and
install the air ination valve using two 5/16" at wash-
ers per valve as supports see Figure "E".
FOLLOW STEPS 1-6
FOR THE OTHER AIR SPRING.
STEP 7 — INFLATE AND TEST
Inate the air springs to recommended operating pres-
sure (see page 1 for operating pressures). With a soap
and water solution, check for air leaks around the ttings
and valve core. We recommend inating and deating
in 5 p.s.i. increments to nd the ideal riding condition for
your vehicle.
STEP — 8 COMPLETION
This now completes the installation. Install the wheels
and torque the lug nuts to the manufacturers specica-
tions. Raise the vehicle and remove the jack stands and
lower the vehicle back onto the ground.
NOTE: Check air pressure on a monthly basis.