User`s guide

Functions for Master-Making
Checking the Print Image Prior to Making Master [Preview]
94
Checking the Print Image Prior to Making
Master
[Preview]
You can check what the actual master will look like by previewing an image of the scanned original or an image of
data sent from a computer. This function is handy for checking the layout or final image of a Multi-Up job.
The operation and display timing differ depending upon the mode.
Note:
• It shows the scanned original as-is. A margin is required when actually printing. Check to make sure that the mar-
gins are sufficient.
• In “Direct Print” operation, [Preview] will be displayed on the Master Making Basic Screen when data is received
from the computer.
)p.57
• When in Link mode (when a Linked Printer is connected), the original image after scanning and prior to output from
the Linked Printer is previewed.
Mode name
(original type)
When set When to display If “Auto Processing” is ON
Printing from the Original
Document
When setting functions
related to Master Making
(settings from Functions)
After Scanning the
Original
Scans the original, then
temporarily stops to display
preview.
Scan Mode When setting functions
(master making functions)
related to Scanning (setting
from Functions)
After Scanning the
Original
When in scan mode, an
original is scanned and then
saved, so there is no “Auto
Process” operation.
However, if multiple originals
are placed in an ADF unit,
you can touch [Close] after
reviewing the preview to
start the scan of the next
original.
Printing Original Data
from a Computer
Stopping the print job prior to
making a master (Pause
before “Master”/Auto-
process “OFF”), after the
machine has received the
original data
Displays when touching
[Preview]
A preview is not shown if
data is sent from the printer
driver with “Auto Print” “ON”.
Retrieving Stored Data
and Printing
When retrieving stored data
(set on the Storage Basic
Screen)
Displays when touching
[Preview]
If you touch [Preview], it
displays immediately.