User`s guide

Basic Operations
Printing from a Paper Document or Book
45
Printing from a Paper Document or Book
The steps for scanning an original for printing is explained below.
Note:
• See “When using a Linked Printer” ()p.204) to print from a Linked Printer with Auto-Link function.
(“Auto-Link” function is not available for RZ1090U.)
1
Make sure the machine is ON.
Check the Control Panel.
Note:
• When the power is OFF, both the Display and
the key are off. Turn the power ON.
• If the key is lit, the machine is in Energy
Saving mode. Press the key to cancel
Energy Saving mode.
2
Check for printing paper.
Make sure paper is loaded.
To load or to change the paper, see the following page:
)p.39
After replacing with paper of a different size,
adjust the position of the Receiving Tray Paper
Guides and Paper Stopper.
)p.38
3
Check the Display.
 When the recognition screen is displayed.
Follow the message on the screen.
For details, see )p.116.
The initial screen will be displayed after the
user has been identified.
 When the initial screen is displayed
Proceed to step 4.
The initial screen differs depending on the set-
ting of “Display Priority” of “Admin.”.
4
Touch [MasterMake] on the Opera-
tion Selection Screen.
The Master Making Basic screen appears.
Note:
• When you see [Data-Map] in the Status Area,
the machine is busy receiving electronic data
from the computer. Please wait a moment.
• If you see Link Basic Screen, press the
key to switch to Master Making Basic Screen.
5
Place the original.
Place the original on the Glass Platen or in the
optional ADF (Auto Document Feeder) unit.
To place the original, see )p.43.
RISO RZ 1070A
Select an Operation Mode
MasterMake
Printing
READY
A4
Line
Black
Page (A4)
Basic Selections Functions Admin.
Contrast
Auto
Size Paper
Idle
Multi-Up
Print
D-Feed
Check
Info
Ready to Make Master