User`s guide

Troubleshooting
Troubleshooting
272
Paper goes over the receiving
tray stopper.
--- Follow the steps to level the receiving tray
as follows:
1) Fold the Receiving Tray Paper
Guides/Stopper.
2) Lift up the sides of the receiving tray
with both hands, and move the
receiving tray shaft to position B.
Position A is recommended in most
cases.
A: Ordinary position
B: Move to this position when paper
goes over the tray.
Paper is not smoothly fed from
the Paper Feed Tray.
(skipped paper, or multiple-
sheet feeding)
The print paper is inappropriate. Use paper that falls within the
recommended range.
)p.17
The position of the Paper Feed
Pressure Adjustment Lever was
inappropriate.
When using thick or slippery paper, set the
Paper Feed Pressure Adjustment Lever to
“Thick Paper”.
)p.36
Multi-up did not function.
There is nothing printed on
one side.
Did you place the second original in
time after the beep, while the
message “Place Another Original and
Press Start Key” was showing?
When you print using “Multi-Up”, the
machine will beep during the Multi-Up
Interval. Place the second original during
that interval.
If the machine starts scanning for the second
time without a beep, even when you are
scanning from the Glass Platen, you will
need to adjust
“ Multi-Up Interval ” settings on
the
Admin. screen.
)p.175
Did you accidentally press the
key while the original was being
scanned?
The print operation will stop if the key
is pressed while scanning is in progress.
Do not press the key until all originals
have been scanned.
Problem Possible Cause Action
A
B