User`s guide

Troubleshooting
Troubleshooting
269
Paper sticks to the surface of
the Print Drum (Cylinder).
The margin at the top of the original or
print is too small.
The margin of the original (top of the print
in the paper output direction) must be
5mm (
3
/
16
") at least. Lower the vertical
print position. If this adjustment is
impossible, reproduce an original with
enough margin and perform the master-
making operation again.
)p.63
The print paper is inappropriate. Use the recommended paper.
)p.17
The original has a solid black portion
at its top.
If an original has a solid black portion at
the top, printed copies may not properly
output. Replace the original in the reverse
direction and restart the master-making
process.
Printed and curled copies are
output.
The print paper is loaded at a
horizontal grain direction.
Load print paper with a vertical grain
direction.
Paper gets jammed in the Auto
Document Feeder AF-VI
(option).
There is any paper caught in the Auto
Document Feeder AF-VI.
Pull the ADF Original Release Lever to the
right or turn the Release Original Dial and
remove the jammed paper.
Problem Possible Cause Action
ADF Original Release Lever
Original Release Dial