User`s guide

Troubleshooting
When a Message Displays
243
T00-000:Service Call Error (in alphabetical order)
A00-000:Jam Errors (in alphabetical order)
Message Possible Cause Action
!!Battery Replacement!!
Call Service
The battery is low or depleted. Contact your dealer (or authorized service
representative) and have the battery
replaced.
Press the key or the key to clear
the error message display.
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
A system error has occurred. Press the key.
If the problem persists, contact your dealer
(or authorized service representative).
!!System Error!!
Turn Main Power SW OFF Then ON
If Recovery has Failed, Call Service
Shut off power, then restart.
If the problem persists, contact your dealer
(or authorized service representative).
Message Possible Cause Action
Master Disposal Error
Pull Out Print Cylinder and
Discard Master
The master was not properly
discarded.
1) Pull out the Print Drum (Cylinder) and
remove the master from the Print
Drum (Cylinder).
)p.231
2) Return the Print Drum (Cylinder) in place.
3) Press the key.
Master Jammed in Disposal Unit
Pull Out Master Disposal Box and
Remove Jammed Master
The master is jammed in the
Master Disposal Unit.
Pull out the Master Disposal Box and
remove the jammed master.
If the masters are difficult to remove, pull out
the Print Drum (Cylinder) and then remove.
)p.229
)p.231
If the error persists, contact your dealer (or
authorized service representative).
Master Loading Error
Pull Out Print Cylinder and
Discard Master
The master did not properly
attach to the Print Drum
(Cylinder).
1) Pull out the Print Drum (Cylinder) and
remove the master from the Print
Drum (Cylinder).
)p.231
2) Return the Print Drum (Cylinder) in place.
3) Press the key.
Master Mis-Feed
Pull Out Master Making Unit and
Rewind Master Roll, then
Reset Master in Place
The master is improperly
installed.
Pull out the Master Making Unit, rewind
the master and reinstall.
)p.224