User`s guide

Advanced Features
Customizing the Direct Access Area [My Direct Access]
166
Customizing the Direct Access Area
[My Direct Access]
Normally, the functions displayed in the Direct Access Area of the Basic Screen are already registered by default set-
ting or changed by the administrator. However, if User Management is set up, each user can register the functions
displayed in the Direct Access Area using “My Direct Access”.
The functions that can be displayed in the Direct Access Area can individually be registered in each mode (Master
Making/Print/Scanning).
Up to 4 functions can be registered.
“My Direct Access” kept by each user can be displayed after the user has been identified and cannot be changed by
other users.
Note:
• “My Direct Access” can be set when “Management Level” is set to “High/Full Management” in “User Management”.
• If “My Direct Access” is not set, the functions registered via the usual methods are displayed in the Direct Access
Area. ()p.178)
1
Touch [My Direct Access] on the
Functions screen.
If “Management Level” is not set to “High/Full
Management” in “User Management”, the [My
Direct Access] button is grayed-out and is not
available.
Note:
• Consult your administrator for Management
Level.
2
Select a mode tab to register new
buttons.
Multi-Up
Print
D-Feed
Check
Ready to Make Master
Black
Direct Access Area
180ppm
Ready to Make Master
Ready to Make Master
D-Feed
Check