Specifications

Troubleshooting
Troubleshooting Tips
97
Paper is not smoothly fed from the
Paper Feed Tray. (No paper is fed.)
The position of the Paper Feed
Pressure Adjustment Lever was
inappropriate.
For thick or smooth-surface paper,
set the Paper Feed Pressure
Adjustment Lever to “ ”. )p.19
The angle of the Stripper Plate is
inappropriate.
If the above adjustment does not
solve the problem, use the following
procedure:
Turn the Stripper Plate Angle
Adjustment Dial in the arrow
direction to adjust the angle of the
Stripper Plate.
Important!:
• Before performing the adjustment,
always remove paper from the
Paper Feed Tray and check that
the tray has been lowered to the
bottom.
Paper is not smoothly fed from the
Paper Feed Tray. (Piled paper is
feed)
The angle of the Stripper Plate is
inappropriate.
Turn the Stripper Plate Angle
Adjustment Dial in the arrow
direction to adjust the angle of the
Stripper Plate.
Important!:
• Before performing the adjustment,
always remove paper from the
Paper Feed Tray and check that
the tray has been lowered to the
bottom.
Paper frequently jams in the paper
feed section even when the Paper
Feed Pressure Adjustment Lever is
set to “ ”.
The angle of the Stripper Plate is
inappropriate.
Refer to the procedure provided for
“Paper is not smoothly fed from the
Paper Feed Tray. (No paper is fed.)”,
and adjust the angle of the Stripper
Plate.
The back of printed cards is peeling
or the leading edge of the printed
cards is wrinkled.
The angle of the Stripper Plate is
inappropriate.
Refer to the procedure provided for
“Paper is not smoothly fed from the
Paper Feed Tray. (No paper is fed.)”,
and adjust the angle of the Stripper
Plate.
Problem Cause Action
ORCH_GB.book Page 97 Thursday, February 19, 2004 2:08 PM