Specifications

Troubleshooting
Troubleshooting Tips
96
Paper sticks to the surface of the
Print Drum.
(The indicator blinks frequently.)
The margin at the top of the original
or print is too small.
The margin of the original (top of the
print in the paper output direction)
must be 5 mm at least. Lower the
vertical print position. If this
adjustment is impossible, reproduce
an original with enough margin and
perform the master-making
operation again.
The print paper is inappropriate. Use the recommended paper.
The original has a solid black portion
at its top.
If an original has a solid black portion
at the top, printed copies may not
properly output. Replace the original
in the reverse direction and restart
the master-making process.
Printed and curled copies are output. The print paper is loaded at a
horizontal grain direction.
Load print paper with a vertical grain
direction.
Printed copies are not neatly aligned
in the Paper Receiving Tray.
(The indicator blinks frequently.)
The positions of the Receiving Tray
Paper Guides and the Paper
Stopper are inappropriate.
Adjust the Receiving Tray Paper
Guides and the Paper Stopper to the
size of paper. For thick paper,
slightly widen them as necessary.
If you have adjusted the horizontal
position on the Paper Feed Tray,
shift the Receiving Tray Paper
Guides in the same direction.
)p.21
The positions of the Paper Ejection
Wings are inappropriate. (For
RZ2XX, unavailable)
Position the Paper Ejection Wings
according to the size and thickness
of paper.)p.21
The Paper Arrangers are not
properly set. (For RZ2XX,
unavailable)
Set the Paper Arrangers properly.
)p.21
The corrugators are not properly set.
(For RZ3XX, unavailable)
Set the corrugators properly. )p.21
Problem Cause Action
ORCH_GB.book Page 96 Thursday, February 19, 2004 2:08 PM