Specifications

Troubleshooting
Troubleshooting Tips
93
An error indication does not
disappear even though
consumables (ink, master roll) are
set.
The consumables (ink, master roll)
have not been correctly set.
After inserting the Ink Cartridge, turn
it clockwise ( ) to lock. Or set the
Ink Cartridge again.
)p.68
Set a master roll so that the
mark comes to the left, and set the
Master Making Unit.
)p.70
The Ink Cartridge does not contain
ink information.
Do not remove the label attached on
the Ink Cartridge outlet section. If
you did so, set a new Ink Cartridge.
)p.68
The master roll does not contain
master information.
Do not remove the section from
the master core. If you did so, set a
new master roll.
)p.70
There is no image on copies. The original is placed face up. Place the original face down. (This is
also true for the ADF unit)
Portion on copies is missing. A foreign object may exist on the
master.
Pull out the Print Drum and check if
any object exists on the master.
If a foreign object exists between the
master and the drum, remove the
master. Then set the drum and
perform the master-making
operation again. )p.83
• The paper size placed on the
Paper Feed Tray was not the
same as the size of the original at
the time of the master-making
process.
• The Feed Tray Paper Guides were
not fit to the width of paper at the
time of the master-making
process.
A master is made according to the
size of paper placed on the Paper
Feed Tray; namely the width of the
Feed Tray Paper Guides and the
length of paper. If the size of paper
placed on the tray is smaller than the
size of the original, a master is not
made for the entire original. Set the
same size of paper on the tray as the
original and perform the master-
making operation.
Problem Cause Action
ORCH_GB.book Page 93 Thursday, February 19, 2004 2:08 PM