Specifications
Troubleshooting
Check & Error Display
90
When the indicator [
*
2] is off and “H” is shown on the Print Quantity
Display [
*
4].
In order to assure optimum printing, the machine acquires information from the consumables.
If acquired matching information is not proper, “H” is shown on the Print Quantity Display.
Enter an appropriate parameter.
Entering an inappropriate parameter does not affect usual operations but may result in bad print quality.
The table shows the “H” numbers to be shown on the Print Quantity Display and the selectable parameters.
: For RZ2XX, unavailable
Note:
• When you perform the following operations, entered H No’s information disappears and thus you need to enter H
No’s again.
– After the power switch is set to (OFF), the switch is set to (ON) again
– After the machine is placed into the Sleep status, the key is pressed
• If you are not sure the best setting for the supply(s) used in the machine, we may suggest you start from 1(default
setting) except for H1 indication and adjust if necessary based on the result of print.
Riso takes no responsibility, and cannot advise as to the best setting, for particular supplies not manufactured and
sold by Riso.
Location
No.
H No. Description Parameter
H1
Ink colour setting
Select the same colour as the currently used for Print
Drum.
1: black 2: colour
H2
Print density fine adjustment (ink)
Perform fine adjustment to optimize the print density
depending on the ink.
1 (light) - 5 (dark)
H3
Sample copy density adjustment (ink)
Perform adjustment for print density for test printing
depending on the ink.
This adjustment is independent of H2.
1 (light) - 5 (dark)
H4
Master-making density setting
Set the reference density for the master-making
process.
1 (light) - 10 (dark)
H5
Print density fine adjustment (master)
Perform fine adjustment to optimize the print density
depending on the master.
1 (light) - 5 (dark)
H6
Sample copy density adjustment (master)
Perform adjustment for the print density for sample copy
depending on the master.
This adjustment is independent of H5.
1 (light) - 5 (dark)
ORCH_GB.book Page 90 Thursday, February 19, 2004 2:08 PM