Specifications

Troubleshooting
Check & Error Display
85
A-01
A-34
A master has not been correctly set. Open the Master Making Unit Cover, remove the
master roll, and set the master correctly. If the
master is loose, turn the right flange inward to
correct it, and close the Master Making Unit
Cover.
)p.70
A-17
A master has not been correctly cut.
1) Remove the master roll and close the
Master Making Unit Cover.
2) Set the master again.
)p.70
A-05
A master jam has occurred in the
master disposal section.
1) Remove the Master Disposal Box.
2) Stand at the side of the Paper Feed Tray
and push down the Master Disposal Roller
Release Lever at the inside right.
3) Remove the master jammed on the roller
section.
4) Push the Master Disposal Roller Lock Lever
inward.
5) Set the Master Disposal Box.
)p.73
J-08
A paper jam has occurred on the
Paper Feed Tray section.
1) Remove the jammed paper.
2) Set paper again.
3) If the error indications do not disappear,
press the key.
Location
No.
Error No. Cause Action
ORCH_GB.book Page 85 Thursday, February 19, 2004 2:08 PM