Specifications

Troubleshooting
Check & Error Display
84
A-02
A master has not been correctly
wrapped around the Print Drum.
BCaution:
• The Print Drum is equipped with many metallic
components. Touch the Print Drum only when
necessary. These components may cut your
fingers.
• When turning the Print Drum with hand, do not
grab the handle on the rear side of the Print
Drum. Be careful that your fingers will not be
caught and hurt.
• When turning the Print Drum with hand, hold
the edge of the Print Drum. If you push on the
master, your fingers may be smudged with ink.
• The Clamp Plate opens while the Clamp Plate
Release Lever is pressed. Be careful that your
fingers will not be caught and hurt.
• The seperated master is covered with ink. Be
careful that the master will not contact with
other objects.
A-04
A master has not been sent to the
Master Disposal Box.
1) Pull out the Print Drum and remove the
master on the drum.
)p.75
2) Set the Print Drum again.
3) Press the key.
A-16
An unnecessary master remains on
the Print Drum.
1) Perform actions 1) through 5) provided for
error No. “A-02”. )p.83
2) Perform the master-making operation again.
J-04
A paper jam has occurred around
the Print Drum.
1) Pull out the Print Drum.
)p.75
2) If you find jammed paper, remove it.
BCaution:
• When putting your hand into the machine to
remove paper, do not touch the paper
separation hook. The sharp tip of the hook
may hurt your hand.
Location
No.
Error No. Cause Action
ORCH_GB.book Page 84 Thursday, February 19, 2004 2:08 PM