Specifications

Troubleshooting
Check & Error Display
83
When the indicator [Area *3] blinks
Check error locations and error numbers (Error Number Display) and take the following procedures:
Location
No.
Error No. Cause Action
A-06
Any obstacle exists under the Paper
Feed Tray or on paper.
Check if any obstacle exists under the Paper
Feed Tray or on paper. If an obstacle exists,
remove it.
A-02
A master has not been correctly
wrapped around the Print Drum.
1) Pull out the Print Drum. )p.75
2) Press the Print Drum Release Lever ( ),
hold the edge of the Print Drum, and turn the
Drum until the clamp plate (metallic plate
locking the master) comes to the top ( ).
3) Press the Clamp Plate Release Lever ( )
to unlock the clamp plate, hold the edge of
the master, and then separate the master
while turning the Print Drum ( ).
4) Turn the Print Drum until the marks
meet.
5) Set the Print Drum into the machine.
6) Pull out the Master Making Unit and set the
master again.
7) Place the Master Making Unit into position.
8) Perform the master-making operation again.
ORCH_GB.book Page 83 Thursday, February 19, 2004 2:08 PM