Specifications

Replacing and Disposing Consumables

Removing and Installing the Print Drum

When replacing with a colour drum or dealing with paper jams, remove the Print Drum, take a necessary procedure,

and then install the drum.

Important!:

• Make sure to place and keep the removed Print Drum horizontal.

• Make sure to place the replaced Print Drum in the drum case and keep it horizontal.

1 Open the Front Cover.

2 Check that the indicator of the Print

Drum Release button is on.

If the indicator is off, press the Print Drum Release

button to turn on its indicator.

:Print Drum Release button

Note:

• With the Master Making Unit pulled out, you

cannot remove the Print Drum.

Place the Master Making Unit into position, and

then press the Print Drum Release button.

)p.70

3 Pull out the Print Drum.

Grasp the Print Drum Handle and pull out the Print

Drum until it stops.

4 Remove the Print Drum.

Lift the Print Drum with both hands to remove it

from the guide.

BCaution:

• Do not touch the connector on the Print Drum.

Neglecting this may result in malfunction of the

Print Drum because of static electricity or other

factors.

ORCH_GB.book Page 75 Thursday, February 19, 2004 2:08 PM