Specifications

Advanced Features

Automatic Sorting into Groups [Programmed Printing]

5 Press the [ ] key.

The machine then allows you to enter the number

of copies for the second group.

Repeat steps 2 through 5 to specify the number of

copies and sets for each group.

6 Place an original.

z When placing on the Platen Glass.

Place an original on the Platen Glass face

down and align its centre with the mark on the

left-hand side of the glass.

z When placing in the ADF unit (option)

Place originals and adjust the Original Guides

to the width of the originals.

7 Make necessary settings.

Make various settings as necessary.

You can set the following functions:

• Image Processing mode

• Pencil

• Dot Process

• Scanning level

• Enlargement/reduction ratio

• Auto-Process

8 Press the key.

A proof copy is printed.

Check the print result; and if necessary adjust the

print position and other items.

9 Press the key again.

Printing is started with the last programmed

group.

Important!:

• When printing is finished for all groups, the pro-

grammed content is cleared. However, it is not

cleared when “Auto-Process” has been set to “ON”.

Note:

• Printing is stopped each time a routine for one

set is finished. If you do not use the Job Sepa-

rator (option), remove printed copies from the

Paper Recceiving Tray or put separation paper.

• To interrupt printing, press the key. Press

the key again to resume printing.

ORCH_GB.book Page 54 Thursday, February 19, 2004 2:08 PM