Specifications

Setting up for Scanning Originals
Printing Originals Side-by-Side [2-Up Printing]
41
Note:
• You can specify the enlargement/reduction ratio by selecting the standard ratios or specify it in increments of 1%
using the Zoom function.
)p.35
• Originals must have sufficient margins. Insufficient margins result in inappropriate page layout.
)p.18
• Original margins are kept regardless of the enlargement/reduction ratio.
• For two-original printing, you can separately select the following functions for each original.
Image Processing mode, Pencil, enlargement/reduction ratio, dot process/scanning level
Operational Procedure
1 Place an original.
z When placing on the Platen Glass
Place the original face down in the vertical ori-
entation. Position it using the mark on the left-
hand side of the glass.
z When placing in the ADF unit (Option)
Place piled originals in the ADF unit. If you
want to separately set the type and size of orig-
inals for each original, place one original at a
time.
Important!:
• The sizes of originals to be placed in the
ADF unit (option) must be 90 mm × 140 mm
at least. For smaller originals, use the Platen
Glass.
2 Press the key to turn on its indicator.
Note:
• To clear the mode, press the key again to
turn off its indicator.
3 Make necessary settings.
As necessary, make various settings including
Image Processing mode selection.
)p.32∼p.37
ORCH_GB.book Page 41 Thursday, February 19, 2004 2:08 PM