Specifications

Basic Operations
Basic Operations
27
Basic Operations
Printing from a Paper Document or Book
1 Set the power switch to (ON) to
turn the power on.
The power switch is located on the lower right side
of the machine.
: Power On
: Power Off
Important!:
• When the machine is in the Energy Saving
mode, the key is lighted. Press the key to
wake up the machine.
Note:
• If data is received from a computer while the
machine is being operated, that data may be
given a higher priority for making a master. To
give a higher priority to an original placed on the
machine, press the key to turn off its indica-
tor.
2 Check the display.
Check that any Check & Error Display section is
not lighted nor blinking.
)p.82
Note:
• When the indicator is lighted, idling action is
activated just before the master-making opera-
tion.
)p.55
3 Place an original.
z When placing on the Platen Glass
Open the Platen Cover and place the original
face down. Align the centre of the original with
the mark on the left-hand side of the glass.
After placing the original, slowly close the
Platen Cover.
Note:
• When placing an original is completed, the
master-making process is automatically
started; the Master-Making indicator on the
Control Panel lights. If the indicator is not
lighted, press the key.
z When placing in the ADF unit (Option)
Place originals face down, and then adjust the
ADF Original Guides to the width of the origi-
nals.
Important!:
• The sizes of originals to be placed in the
ADF unit must be 90 mm × 140 mm at least.
For smaller originals, use the Platen Glass.
Note:
• You can place up to about 50 sheets of orig-
inals in the ADF unit.
ORCH_GB.book Page 27 Thursday, February 19, 2004 2:08 PM