User`s guide

Utility Software Guides
RISO-ADMIN features
15
Configuration procedure
You can specify various network configurations in this dialog box and apply them to RISO printers on the network as
described below.
1
Opening RISO-ADMIN.
Select [RISO] - [RISO Network Card] from the
[Program] list in the [Start] menu and click on
[RISO-ADMIN].
2
Select a desired RISO printer.
Highlight a desired RISO printer name (or icon) in
the RISO-ADMIN main window.
3
Click on [Network Parameters] in the
[Configure] menu.
The [Network Parameters] dialog box then
appears.
Note:
• If a password is specified for the selected RISO
printer, the [Password] entry box appears in
this step. In this case, enter the specified pass-
word. (See "[General] Tab" on the page
)p.16.)
• If you want to select RISO printers on other
local area networks as well as on the current
one, specify the corresponding Broadcast
addresses in the [Properties] dialog box. (See
"[Properties] dialog box" on the page )p.19
for detailed descriptions.)
4
Specify a desired network configura-
tion and click on the [Setup] button.
The confirmation message box then appears.
5
Click on the [OK] button in the mes-
sage box.
The specified network configuration data are sent
to the selected RISO printer and another message
box appears.
6
Click on the [Yes] button in the mes-
sage box again.
The specified network configuration is then
applied to the selected RISO printer.
Note:
• The displayed message box may request you to
reboot the selected RISO printer if the printer
has older system configuration. In this case,
turn off the power switch of the selected RISO
printer and turn it on again after you click on the
[Yes] button in the message box.