User`s guide

77
Appendix
Problem
Your RISO printer cannot finish
processing the current document
data.
Your RISO printer won’t start making
master when the documentation data
is transmitted from your computer or
your RISO printer won’t start printing
after making master.
Cause / Condition and Action
❑ The printer cable (or network cable) was removed just after a
print job started in the application software. ([Printing] is
displayed when you open the [RISO...] printer monitor
window in this case.)
Action
Reconnect the cable and cancel the current job in the
[RISO...] printer monitor window. Then turn off the
main power switch of your RISO printer. After approxi-
mately 10 seconds, turn it on again.
❑ [Pause] is displayed as the printer status when you open the
[RISO...] printer monitor window.
Action
Click on the [Restart] in the [Document] menu in the
[RISO...] printer monitor window.
❑ The printer settings (paper size, print orientation, etc.) in the
application software and in the Printer Driver do not match.
Action
Change the printer settings in the application software
to make them identical with those in the Printer Driver
or vice versa, and repeat the print job from the appli-
cation software.
❑ The print job has been canceled before completion in the
application software on your computer.
Action
Turn off the main power switch of your RISO printer.
After approximately 10 seconds, turn it on again.
❑ If you set the [Process] to a setting other than “Full-auto”,
the process stops in operation in order to wait for instruc-
tions.
Action
Press Start key on your RISO printer. The next
process starts.