Specifications
Troubleshooting
Troubleshooting Tips
75
Dirt is found on printed copies. The Scanner Glass of the DF Unit is
not clean.
Wipe the Scanner Glass with a soft
cloth or others.
)p.60
The trailing edge of printed copies
are stained with ink.
The size of original is almost equal to
the maximum printing area size.
Reduce the size of original and make
a Master again.
)p.12
The edges of printed copies are
smudged with ink.
When printing thick paper such as
cards, corners of the paper
contacted and damaged the master.
Make another master and print with
the new master.
Or pull out the Print Drum (Cylinder)
and attach cellophane tape to the
damaged section on the master.
However, if attached with cellophane
tape, a master may not be properly
sent to the Master Disposal Box.
The back of printed copies is
smudged with ink.
The Pressure Roller has been
stained with ink.
Pull out the Print Drum (Cylinder)
and open the Master Disposal Unit,
wipe the Pressure Roller with a soft
cloth or others.
)p.61
If the print position is outside the print
paper, this may cause the Pressure
Roller to be stained with ink. Be
careful when changing the size of
print paper or shifting the print
position.
)p.35
Printed images are faint.
Printed texts are blurred.
The machine was not used for an
extended period of time, and printing
was just restarted.
If the machine is not used for an
extended period of time, ink on the
surface of the Print Drum (Cylinder)
may dry. This results in faint or
blurred printing just after printing is
started.
Press the key to make several
copies, and then start printing for
actual use.
Faint originals result in faint images. Increase the Scanning Level and
perform the master-making
operation again.
)p.29
For originals written with a pencil,
select the Pencil mode.
)p.27
The machine is installed or the Ink
Cartridge is stored at low
temperatures (below 15° C (59° F)).
Use the machine after keeping it at
room temperature for a while.
Problem Cause Action
KZ30_UG.book Page 75 Monday, December 21, 2009 11:11 AM