Specifications

Troubleshooting
Check & Error Display
67
A-01
A-34
A master has not
been correctly set.
Open the Master Making Unit Cover, remove the master roll,
and set the master correctly.
)p.52
1) Remove the master roll and set the master again.
2) Close the Master Making Unit Cover.
)p.52
3) Press the key.
A-17
A master has not
been correctly cut.
1) Open the Master Making Unit Cover, cut the master with
scissors, etc.
2) Close the Master Making Unit Cover.
3) Press the key.
4) Pull out the Print Drum (Cylinder) and remove the master
from the Print Drum (Cylinder) by hand.
5) Set the Print Drum (Cylinder) again.
JXX
Paper jammed in
the Paper Passing
area.
Check all the lighting sections in the Paper Passing area.
A paper jam has
occured on the
Paper Feed Tray
section.
1) Press the Paper Feed Tray Lock Lever to lower the Paper
Feed Tray, and remove the jammed paper.
If you cannot remove the jammed paper, remove it while
pressing the Jam Release Lever ( ).
2) Set paper again. Then flip the lever up.
3) If the error indications do not disappear, press the key.
Location No.
Error
No.
Cause Action
KZ30_UG.book Page 67 Monday, December 21, 2009 11:11 AM