Specifications

Troubleshooting
Check & Error Display
65
When the (JAM) Indicator blinks
Check error locations and error numbers (on the Error Number Display) and take the following procedures:
Location No.
Error
No.
Cause Action
A-02
A master has not
been correctly
wrapped around the
Print Drum
(Cylinder).
1) Pull out the Print Drum (Cylinder). )p.61
* If no master is wrapped around the Print Drum (Cylinder),
proceed to Step 6). If wrapped, proceed to Step 2).
2) Press the Print Drum (Cylinder) Release Lever ( ), hold
the edge of the Print Drum (Cylinder), and turn counter-
clockwise the Drum (Cylinder) until the clamp plate
(metallic plate locking the master) comes to the top ( ).
3) Strongly press the Clamp Plate Release Lever ( ) to
unlock the clamp plate, hold the edge of the master, and
then separate the Master while turning the Print Drum
(Cylinder) ( ).
4) Turn the Drum (Cylinder) counter-clockwise until it reaches
the position where it is secured by the Drum (Cylinder)
Release Lever (the position where the clamp plate is
exactly next to the right frame).
5) Set the Print Drum (Cylinder) into the machine.
If the Drum (Cylinder) cannot be set, it has not been
secured correctly. In this case, perform step 4 again.
6) Open the Master Making Unit Cover and set the master again.
7) Close the Master Making Unit Cover.
8) Press the key.
9) Perform the master-making operation again.
BCaution:
• The Print Drum (Cylinder) consists of a lot of metallic parts.
Do not touch those parts more than necessary.
Your hand may be cut.
• When rotating the Print Drum (Cylinder) during maintenance,
hold the outer edge of the Print Drum (Cylinder). Your hands
may become dirty with ink if you press the master wrapped
around the Print Drum (Cylinder).
• The clamp plate is open when you are pressing the Clamp
Plate Release Lever. When you release the lever, the clamp
plate closes. Take extreme care not to be pinched,
otherwise, your hand may be injured.
• When you remove the master from the Print Drum (Cylinder),
the ink is spread on the master. Take care not to allow the
master to come in contact with other parts or objects.
A-16
Unnecessary
master remains on
the Print Drum
(Cylinder).
KZ30_UG.book Page 65 Monday, December 21, 2009 11:11 AM