User`s manual
2-36
5.3 Separation Paper
If you use "4.6 Job Separation", specify the feed tray in which the separation paper is loaded.
~
~~
~ Settings
The separation paper can be used even if the size and the orientation are different from those of the printer paper.
• The separation paper tray is used exclusively for Job Separation. If "Menu 6 Feed Tray Selection" is set to "Auto" and "Menu
4.4 Feed Tray Relay" is set, this feed tray is not used for printing.
• If the separation paper tray runs out of paper during printing, no-paper error will be displayed and printing stops temporarily.
• If a finisher is connected, paper in the separation paper tray can be added as a front cover or a back cover by using the "Add cover"
function of the finisher. In this case, specify the tray in which cover sheets are loaded. If "OFF" is set, an error will be displayed
when printing is performed.
Caution in the following case
If paper larger than the paper for printing or paper of a different orientation is specified as sep-
aration paper, the stack guides are spread according to the larger paper size. Printed paper,
therefore, may not be arranged properly.
1 Use steps 1 to 4 ()
))
)p.2-31) to display
"Administration."
2 Press the or key to display
"Separation Paper."
3 Press the OK Key.
The submenu of separation paper appears.
4 Press the or key to set.
5 Press the OK Key.
When the screen in step 1 reappears, you can continue
setting.
To exit the setting, press the PRINTPAUSE key.
OFF The separation paper tray is not specified. Printing stops for a few seconds in place
of insertion of separation paper.
Standard Feed Tray The Standard Feed Tray is used for separation paper.
Feed Tray 1 Feed Tray 1 is used for separation paper.
Feed Tray 2 Feed Tray 2 is used for separation paper.