Specifications

Advanced Features
Automatic Sorting into Groups [Program]
58
6 Place an original.
z When placing on the Glass Platen.
Place an original on the Glass Platen face
down and align its center with the mark on the
left-hand side of the glass.
Important!:
• Place an original from the last page.
(ex. When printing 3-page originals, place
them in order of 3->2->1.)
z When placing in the ADF unit (option)
Use the ADF unit if you are printing multiple
originals in succession. Place originals face
down and then adjust the ADF Original Guides
to the width of the originals. Insert the originals
as far into the ADF unit as possible. (The orig-
inal on the top will be scanned first.)
Note:
• When “Auto process” is set to ON, printing
will continue automatically for all the origi-
nals.
7 Make necessary settings.
Make various settings as necessary.
You can set the following functions:
• Image Processing mode
• Pencil
• Dot Process (For EZ3XX only)
• Scanning level
• Enlargement/reduction ratio
• Auto-Process
Important!:
• To save the current program settings, see “Sav-
ing Programs” ()p.59) for further information.
Once printing is finished, the settings cannot be
saved.
8 Press the key.
A proof copy is printed.
Check the print result; and if necessary adjust the
print position and other items.
9 Press the key again.
Printing is started with the last programed group.
Important!:
• You need to press the key each time to print
an original placed on the Glass Platen and replace
the original once printing is finished.
Note:
• Printing is stopped each time a routine for one
original is finished. If you do not use the Job
Separator (option), remove printed copies from
the Paper Recceiving Tray or put separation
paper.
• To interrupt printing, press the key. Press
the key to resume printing.
REG-LL_EN.book Page 58 Wednesday, September 14, 2011 12:03 PM