Specifications

Setting up for Scanning Originals
Enlarging and Reducing Originals [Enlargement/Reduction]
37
Enlarging and Reducing Originals
[Enlargement/Reduction]
You can enlarge or reduce originals when printing.
Specify the enlargement/reduction ratio by selecting the standard ratios; or specify it in increments of 1%.
Enlarging and Reducing by Standard Ratios
[Standard]
Select the standard ratios when enlarging or reducing standard-sized originals to another standard size or when
increasing margins around the original.
Press the / keys to specify the
enlargement/reduction ratio.
Each time you press the key, the indicator of the
selected ratio lights.
To restore 100%, press the key.
The standard enlargement/reduction ratios differ
among the models.
Check the panel on your machine.
Note:
• To avoid paper jam, flipping or ink smudges on the
back side by design, the machine does not print too
close to the edge. The top edge in particular needs
5 mm (
3
/
16
") of margin space.
)p.19
5 mm (
3
/
16
") wide area on the top edge (marked ) of
the Glass Platen (or the ADF unit) cannot be
scanned, regardless of enlargement or reduction set-
tings.
• Do not position the original within 5 mm (
3
/
16
") of the
top edge, or the top edge of its printed image will be
cut off.
• If the original document has no margin on its top
edge, the top 5 mm (
3
/
16
") of its print will be cut off
even when “Margin+” is selected. Move the original
about 5 mm (
3
/
16
") inwards from the top edge of the
Glass Platen and reduce the size.
REG-LL_EN.book Page 37 Wednesday, September 14, 2011 12:03 PM