Specifications

Troubleshooting
Troubleshooting Tips
119
Paper is not smoothly fed from the
Paper Feed Tray.
(skipped paper, or multiple-sheet
feeding)
The print paper is inappropriate. Use paper that falls within the
recommended range.
)p.16
The position of the Paper Feed
Pressure Adjustment Lever was
inappropriate.
When using thick or slippery paper,
set the Paper Feed Pressure
Adjustment Lever to CARD ( ).
)p.20
The angle of the Stripper Plate is
inappropriate.
Turn the Stripper Plate Angle
Adjustment dial as follows;
• When the feeding skips
Turn the dial to the left.
• When multiple sheets are fed
Turn the dial to the right.
Important!:
• Before making the adjustment, be
sure to remove all paper from the
Paper Feed Tray and confirm that
the tray has lowered to the bottom.
The Paper Feed Adjustment on the
Functions screen is not properly set.
Adjust the “Paper Feed Adj.”.
Contact your dealer (or authorized
service representative) for details on
making the adjustment.
The back of printed cards is peeling
or the leading edge of the printed
cards is wrinkled.
The angle of the Stripper Plate is
inappropriate.
Refer to the procedure provided for
“Paper is not smoothly fed from the
Paper Feed Tray. (No paper is fed.)”,
and adjust the angle of the Stripper
Plate.
The indicator lights even when a
paper jam has not occurred.
Lifted paper was ejected at the time
of the second rotation of the Print
Drum (Cylinder).
Check the printed copies, and if the
top margin is less than 5 mm(
3
/
16
"),
slightly lower the print position.
Because sunlight was projected to
the machine, the sensor did not
function correctly.
Use a curtain for example to shut out
sunlight or move the machine to a
place free from direct sunlight.
Problem Cause Action
REG-LL_EN.book Page 119 Wednesday, September 14, 2011 12:03 PM