Specifications

Troubleshooting
Troubleshooting Tips
116
Printed images are faint.
Printed texts are blurred.
If the machine is not used for an
extended period of time, ink on the
surface of the Print Drum (Cylinder)
may dry. This results in faint or
blurred printing just after printing is
started.
The ink on the Print Drum (Cylinder)
will dry when the machine is not in
use for an extended period. Printing
with dried ink will produce light or
faded copies.
Press the key and make several
copies before making copies to be
actually used. Or use the “Idling
Action”.
)p.64
Faint originals result in faint images. Increase the scanning level and
perform the master-making
operation again. )p.39
For originals written with a pencil,
select the Pencil mode. )p.35
If the temperature is low (below
15°C or 59°F) in a place where the
machine is installed or Ink Cartridges
are stored, ink does not flow
smoothly.
Use the machine after keeping it at
room temperature for a while.
)p.12
The Ink Saving mode has been set. With the Ink Saving mode selected,
the ink on printed copies is fainter
than usual.
The left and right print positions have
been shifted.
The left and right print positions have
not been adjusted for the center.
The Paper Feed Tray is equipped
with the Horizontal Print Position
Adjustment Dial. Lower the tray,
adjust the position, and then perform
proof copy to check the
position.)p.48
Paper sticks to the surface of the
Print Drum (Cylinder).
(The indicator blinks frequently.)
The margin at the top of the original
or print is too small.
The margin of the original (top of the
print in the paper output direction)
must be 5 mm(
3
/
16
") at least. Lower
the vertical print position. If this
adjustment is impossible, reproduce
an original with enough margin and
perform the master-making
operation again.
The print paper is inappropriate. Use the recommended paper.
The original has a solid black portion
at its top.
If an original has a solid black portion
at the top, printed copies may not
properly output. Replace the original
in the reverse direction and restart
the master-making process.
Printed and curled copies are output. The print paper is loaded at a
horizontal grain direction.
Load print paper with a vertical grain
direction.
Problem Cause Action
REG-LL_EN.book Page 116 Wednesday, September 14, 2011 12:03 PM