Specifications

Troubleshooting
Check & Error Display
108
d-05
A master roll has not been set or has
not been correctly set.
Set a master roll correctly and close the
Master Making Unit Cover.
)p.90
If a rewound master has been wrinkled or has
worn off, cut the edge of the master straight
and then set the master again.
d-08
The Master Making Unit has not been
correctly set.
Set the Master Making Unit correctly.
)p.90
d-09
The Master Making Unit Cover has not
been closed.
Pull out the Master Making Unit and close the
Master Making Unit Cover completely.
)p.90
d-17
An inappropriate master roll has been
set.
Set a master roll specific to the machine.
The section on the master core is
missing, or it has worn off, or it has
been tilted.
The section on the master core contains
information needed for making masters.
If the machine cannot read the information, it
does not operate. Set a dedicated Master Roll
that has the mark and is free from wear
and tilt.
d-07
The Master Disposal Box has not been
set or has not been correctly set.
Set the Master Disposal Box correctly.
)p.93
F-37
Originals have been placed in the ADF
unit (option) in the Book shadow
editing.
Press the key and then place an original
on the Glass Platen.
Or quit the Book shadow editing. )p.40
b-01
A card has not been set to the Key
Card Counter (option).
Set a card to the Key Card Counter.
b-22
Power to the Job Separator (option) is off. Turn on the power to the Job Separator.
b-23
The Job Separator (option) has run out
of tape.
Set new tape to the Job Separator.
b-24
A tape jam has occurred in the Job
Separator (option).
Check the Job Separator and remove the
jammed tape.
Non
b-33
An IP address has not been set for the
machine.
Using the Custom Setting mode, set the IP
address for the machine.
)p.75
F-04
The count reached the set upper limit
while an identified user was printing.
Press the key to release the error. Then
contact the administrator to clear the TC or
MC.
F-38
The PIN code entered when
registering a user has been already
registered.
Press the key to release the error. Then
enter an unregistered PIN code.
F-39
A PIN code of a disabled user has
been entered.
Press the key to release the error.
Location
No.
Error No. Cause Action
REG-LL_EN.book Page 108 Wednesday, September 14, 2011 12:03 PM